172B

Oberdorfer 172B

172B Oberdorfer

Description:
172B 3/4" Centrifugal Pump

Model#: 172B | Series#: 172B

Price: $7600

Availability: Ships within 2 to 3 weeks
$7600 /ea
Quantity
Ships from US
select 2 to 4 items to compare.

These Oberdorfer™ centrifugal pumps have a single open vane rotating impeller. Liquid enters at the center and is thrown outward radically by centrifugal force. The impeller is not in contact with other pump parts resulting in quiet, efficient pumping action. The flow produced is not positive which permits the discharge line to be shut off completely without danger of overloading motors or bursting lines. Consequently, a relief valve is not required.

The flow of these pumps can be conveniently controlled by a throttling valve in the discharge line. Horsepower demand will decrease as the pressure increases. Maximum horsepower occurs with a wide open discharge.

FEATURES
  • Rugged corrosion resistant bronze construction
  • Compact and light
  • Mechanical Seals - Type 6A
  • Nitrile Standard
  • Fluoroelastomer Options
  • TEFC Motors with corrosion resistant passivated 316 SS Shafts
  • 1/10 HP permanent Magnet 12V, 24V, 32V DC Motors
  • Insulated leads
  • Rubber base grommets for vibration dampening
  • 1/13 HP Permanent Magnet 12V DC Motor
  • 172L threaded shaft style
  • 1/8 HP Capacitor Start 50/60 HZ, 115V & 220V AC Motors
  • Ignition protection
  • Thermal overload protection
  • Power cord with plug

Ideal for:

  • Marine Air Conditioning
  • Engine Block Temperature Control
  • Radiator and Heat Exchanger Circulation
  • Baitwell Circulation
DRIVE

One of the outstanding features of this pump and motor unit is its compact size. Although small, adequate motor power is available. A.C and D.C. motors are available.

LIQUIDS TEMPERATURES

This pump is more than capable of pumping water, water solutions, and a wide range of commercial chemicals.

Viscous liquids with a maximum viscosity of 2000 Saybolt Seconds Universal can be pumped. However, when pumping viscous liquids (as compared with water) a reduction in flow and pressure occurs and the required horsepower increases. Liquids heavier than water require additional horsepower in direct proportion to the increase in specific gravity.Questions about the chemical compatibility of special liquids should be referred to the factory. The pump uses a mechanical type shaft seal with a Nitrile rubber element. It is suitable for water, oils, and some mild solvents and is limited to 212° F, fluoroelastomer is available for up to 400° F.

SUCTION LIFT

These pumps are not self-priming. They must be installed below the liquid level so that the liquid flows to the pump by gravity (flooded suction). However, if a foot valve is used in the beginning of the suction line, and all air is bled from the pump by manual priming, the pump will lift on the suction side up to 15 feet. Such a system relies entirely on the non-leaking foot valve for starting capability.



 

 

 

Customer Questions & Answers

Don't see what you're looking for? Ask the Community
Searching for relevant results...
Typical questions asked about products:
  • Is the item durable?
  • Is this item easy to use?
  • What are the dimensions of this item?

Customer Reviews

1 Star
0%
2 Star
0%
3 Star
0%
4 Star
0%
5 Star
0%