N4000

Oberdorfer N4000 Bronze Gear Pump

N4000 Oberdorfer Bronze Gear Pump

Description:
N4000 1/2" NPT Bronze Gear Pump

Model#: N4000 | Series#: N4000

Price: $44400

Availability: Ships within 2 to 3 weeks
$44400 /ea
Quantity
Ships from US
select 2 to 4 items to compare.

Pump housings and gears are made of top quality bronze, shafts are 303 stainless steel. Bearings are made of high performance carbon-graphite material selected for wear resistance and long service life. Gear pumps are positive displacement pumps. Each shaft revolution displaces a definite amount of liquid relatively unaffected by the backpressure in the discharge line. Shaft speed and flow are directly proportional.

FEATURES
  • Bronze Corrosion Resistant Castings
  • Special Cast Bronze Helical Gears For Quiet Operation
  • Stainless Steel Shafts & Fasteners
  • Synthetic Braided Compression Packing (with Polytetrafluoroethylene (PTFE) dispersion) is Standard
  • Optional Lip Seals Are Available
  • Positive Displacement Flow
  • Bronze Bearing Surfaces With Grease Fittings
DRIVE

Either direct drive with flexible coupling or pulley drive can be used. Make sure both flexible coupling halves are properly aligned. When using a pulley, do not over tighten the belt. Also, to absorb belt side thrust at higher pressures and larger size pumps, an external ball bearing support is recommended -- consult factory.

LIQUIDS & TEMPERATURES

Service life will be increased substantially if the liquid pumped is clean and has some degree of lubricity. These positive displacement pumps have tight tolerances. Fine abrasives like sand, silt, or powders in suspension will accelerate pump wear and reduce throughput. Liquids compatible with bronze and stainless steel can be pumped providing proper seal has been specified (see chemical compatibility or check factory). No carbon bearings used. When possible, flush the pump after each usage. Temperature extremes are detrimental to service life and should be avoided. Basic metals of construction allow a temperature range of -40 to 400oF. Some lip seal elastomers have a limit of 212oF. (see engineering data or check factory). Allowing a liquid to freeze in the pump can cause damage.

SUCTION LIFT

Close tolerances and the positive pumping action make the rotary gear pump capable of lifting water on the suction side as high as 20 feet. Though gear pumps are self priming, a foot valve is recommended. If possible, wet the gears with liquid to be pumped for the first dry start. Liquid retained in the system and gear chambers serves to “wet” the pump on subsequent starts.

*For pressures over 100 psi, the above selections are suitable for pumping fluids with lubricity (e.q. oils, polymers). Service life will decrease for fluids without lubricity (e.q. water, solvents).



 

 

 

Customer Questions & Answers

Don't see what you're looking for? Ask the Community
Searching for relevant results...
Typical questions asked about products:
  • Is the item durable?
  • Is this item easy to use?
  • What are the dimensions of this item?

Customer Reviews

1 Star
0%
2 Star
0%
3 Star
0%
4 Star
0%
5 Star
0%